Application of OPS casings
- construction of cable connections and measurement-cable
connections
- cable cabinets and street lighting cabinets
- low tension boards and switchboards
Type of OPS casings
- detached
- recess-mounted
- wall-mounted
Description of OPS casings
OPS type casings are assembled from plates
made of thermosetting plastic. The OPS casings by Sypniewski Sp. z
o.o. may be 250 mm deep
The door of the OPS type casings open to an
angle of 180 degrees. The HS lock provides two-point locking of the
door.
Additionally, each OPS casing may be insulated
from the foundation by applying a “closed” bottom. “Open” bottoms
may also be applied. This refers both to casings with foundation and
without foundation.
OPS casings may be divided into chambers by applying a rigid
partition made of the side walls of the casings (thermosetting
plastic). The foundations of the OPS casings consist of side walls –
legs plus 4 foundation screens. The foundation screen may be used as
the bottom of the casing, as well as flat roof.
Identification of OPS casings:
The OPS casings may be constructed as follows:
OPS 26 - casing without foundation with flat roof
OPS 26 D - casing without foundation with steep roof
OPS 26 F - casing on foundation with flat roof
OPS 26 DF - casing on foundation with steep roof
Furnishing and assembly of electrical
apparatuses in OPS casings
Inside of the OPN casings places for fixing
angle bars are provided. The angle bars may be fixed at various
depths, for the purpose of assembling the mounting metal plates.
There is a possibility to screw the mounting metal plates to the
back wall of the casing – in this case no angle bars are needed. The
furnishing comprises, among others: angle bars, mounting metal
plates.
Additionally, the casings may be provided in a
round insight hole to read the meter, HS lock or HS ear-lock for
padlock, plus the chosen lock insert. The available locks are black
or grey.
|
